1. Remove the 6000 series radio utilising the
removal tools. Only disconnect the power supply if you have the radio code. Set
the unit aside. When inserting the radio tools, exert caution and only depress
to the 46mm marker on the tools: the clips are extremely fragile.
2. Remove the two Torx screws in each side of
the radio aperture.
3. Unclip the fascia around the clock.
4. Remove the two screws in this recess.
5. Lever out the entire console framework by
some 4/5 cm.
6. Slide the bracket between the right edge of
the framework and console wall at radio level.
7. Locate the bracket with Torx screw
8. Refit the parts in reverse.
NB If the fascia panel requires complete
removal for the application of a an interface cable, then unclip the gear lever
trim and the two phillips screws at the base of the console panel. These are
slightly hidden and will need locating with a torch.
