Nissan Altima (98 on) Dashmount Bracket

Step 1: Begin by removing the trim bezel that surrounds the shifter knob. To do this, pull up on the trim bezel at the rear until clips are released. A flat bending tool or hook tool is recommended. Continue around bezel until all 4 clips are released. Lift trim over shifter knob and set aside.

Step 2: Next, remove the two Phillips screws that are located in front of the shifter knob. Set aside. Remove the two Phillips screws below the climate control and set aside. With the flat bending tool, carefully remove trim bezel that surrounds the radio and climate control. Set aside.

Step 3: Remove the screw to the right of the climate control. Position the Dash Mount over this hole and replace factory screw. Reassemble the dash in reverse order.

Recommended Professional Installation Service:
If like many of our customers, you would prefer an Installation Professional to help, we highly recommend InCar-Installer.com the UK's Leading In-Car Nationwide Installation Service company.

Alternatively look in your local Yellow Pages under the (Car Electrics & Car Audio) categories or visit Yell.com to find an installer in your area. If you would like to have the installation carried out at your home or workplace, look for a mobile installer in the advert or ask when you call them if they offer this service. You'll be surprised, that you find it's cheaper for someone to call to you and install it than to leave it at some fancy garage.